How To Repair Gerber Shower Faucets

After years of use, a Moen Chateau tub and shower faucet plastic handle will sometimes become grating and strong to pull out. This is relatively piece of cake to remedy.

Outset, shut off the water supply. Open up the faucet to drain out the h2o pressure. Then put a rag over the tub drain to catch any parts that drop into the tub.

Using a sharp edge like a fine-bladed pocket-size screwdriver, pry off the handle cap, being conscientious not to mar the plastic terminate. Underneath that cap unscrew the handle screw and pull the handle off.

Pull the chrome tube underneath the handle straight off.

You lot volition find a modest copper tab sticking up above the faucet body. Grasp information technology with a pair of needle olfactory organ pliers, pull it direct upwardly until the copper forks clear the faucet body. Identify this keeper in a safe place because it is piece of cake to lose.

Notation the finish of the brass shaft that sticks out of the faucet body. On the top side of the end of the shaft there is a small apartment surface. This surface must face up when you put the faucet back together.

A Moen faucet cartridge removal tool is the easiest tool to utilise for pulling the cartridge out of the faucet trunk, particularly if it is hard to remove due to corrosion or debris in the faucet trunk. Obtain this tool at a local plumbing shop; some hardware stores may carry them, or yous may exist able to order it from http://www.moen.com. Alternatively, you can use a pair of pliers. Grasp the end of the stem carefully, twist, and pull straight out.

Once y'all have the cartridge removed, inspect the faucet trunk. Make clean it out with a toothbrush or accept an assistant turn the water partially on very briefly to flush out the faucet torso.

Inspect the faucet cartridge. If it is damaged or has a lot of droppings or corrosion, replace it with a new one. These are unremarkably readily bachelor at hardware stores or home centers.

Lubricate the new cartridge with a adept quality stem lubricant. Food grade silicone lubricant works best.

Moen Chateau tub and shower faucet

Install the cartridge with the Moen cartridge removal tool or push button information technology into the faucet body with your fingers, making certain the flat on the terminate of the cartridge faces up.

With the cartridge fully seated in the faucet body, install the small copper keeper. Just push it down until information technology is fully seated in its slot. You tin tell if it is installed properly considering you lot won't be able to install the chrome sleeve or tube unless it is.

At present place the handle over the stem, install the handle screw being careful not to over tighten it. Push the plastic cap in place, turn on the water, and exam your repair.